Kyria rev2 Case Puck Plates
This page is for the Kyria, revision 1.3 to 2.1. This is an older version. For the rev3.x version, please visit the Kyria rev3 Low Profile Case page.
This option is for you when you already have a non-puck case you'd like to upgrade. If you don't have a case yet, you don't need the upgrade and can choose to get a case with puck support directly.
To allow you to upgrade your Kyria case, you'll need a Kyria revision 1.3 up to 2.1, and a top plate with four additional holes that align with the puck mounting holes. Please check this before purchasing, as these replacement plates won't have much use with an incompatible revision.
The tenting puck was first made available in March 2021, while the Kyria has been puck compatible for a good few months before. Chances are you might want to upgrade your Kyria case to be compatible with the puck, which you're able to do with these replacement plates.
The puck is mounted to the Kyria PCB. This makes it able to sit flush with the bottom of the Kyria, which in turn allows you to use the Kyria both tented and untented comfortably without having to remove the puck. These plates have a hole cut out in the right spot so that there is room for the puck.
- Two 3mm acrylic bottom plates;
- 12 rubber bumpons.
This listing is for replacement bottom plates only, and will not include mounting hardware. You can reuse the existing hardware of your case.